Cleaning And Maintenance - BOMANN WA 7160 TL Bedienungsanleitung, Garantie

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

Capacity

Do not overload the appliance otherwise the laundry

is not getting clean. Refer to the information in the

"Program table".

Starting the program

• Connect the appliance to the power supply and

switch it on.

• The water supply must be opened to the maxi-

mum pressure.

• Load your laundry and fill in the detergent, if nec-

essary.

• Close the drum hatches and the unit lid properly.

• Set the required washing conditions.

• Start the operation.

Appliance lid lock

WARNING:

Never attempt to force open the appliance lid during

operation.

Once a wash program has been started, the appli-

ance lid cannot be opened.

When the wash cycle is finished, the lid lock will au-

tomatically be unlocked.

Changing the program

• To change the program, first interrupt the washing

process.

• Switch the device briefly off and then on again.

• Select the desired program and start the new

operation.

End of program

At the end of the wash cycle several beeps sound; a

few minutes later, the lid lock is released and the

appliance enters off- mode automatically.

Switching off

• Close the water supply!

• Leave the appliance lid slightly open until the next

wash cycle to avoid odors.

• If the appliance is not in use for an extended peri-

od, disconnect the mains plug or switch off or turn

out the fuse.

Energy saving tips

• If possible, avoid the selection of high wash tem-

peratures. Modern detergents achieve good

washing results even at low temperatures.

• Select the wash program depending on the type

of laundry and the required degree of washing.

• Take advantage of the maximum capacity of each

wash program.

• Clean the filter regularly to avoid excessive wash-

ing and high energy consumption.

• Ventilate the room well. The room temperature

should not rise above +35°C.