Technical Specifications - BOMANN DBS 775 R CB Bedienungsanleitung

Start ironing after starting up the appliance and filling the water
tank.
• Wait for the iron to heat up.
• Steam jet: press button (1) on the iron.
• Continuous steam: slide the locking lever (2) to lock button
(1) in place.
• Select amount of steam: press one of the three steam
buttons to select the amount of steam.
How can I replenish the water during operation?
Refill with water before the tank is completely empty. The "Tank
empty" indicator shows that the amount of water in the tank is
not sufficient.
• Unlock the locking lever (2) in case you worked with con-
tinuous steam.
• Place the iron on the rest (7).
• Set the temperature control to "MIN".
• Set the On/Off switch to OFF position.
• Remove the mains plug from the socket.
• Fill the tank up to the maximum mark. Do not overfill!
Note:
You can also detach the tank for filling.
• Replace the tank on the base, if detached.
• You can now continue ironing.
When you have finished
• Always turn the temperature control to "MIN" after use and
remove the mains plug (the control lamp in the handle goes
off).
• Set the On/Off switch to OFF position.
• Remove the mains plug from the socket.
• Empty the water tank.
• Allow the device to cool down before you put it away.
Scale Filter
Your steam station is equipped with a scale filter. The scale fil-
ter cartridge lasts approx. 500 operating hours. After this period
the "Descale" button indicates with light and beep signals to
replace the cartridge.
• Press the "Descale" button to acknowledge the message.
• Set the On/Off switch to Off position.
• Detach the water tank.
• Turn the scale filter cartridge a quarter turn counter-clock-
wise to remove.
• Replace the scale filter cartridge.
Note
Continue ironing with distilled water if you have no scale filter
cartridge at hand.
Caution
Leave the scale filter cartridge always attached!
Cleaning
Warning:
► Always remove the mains lead before cleaning!
► Wait until the machine has cooled down completely!
► Under no circumstances should you immerse the device
in water for cleaning purposes. Otherwise this might result
in an electric shock or fire.
Caution
► Do not use a wire brush or any abrasive items.
► Do not use any acidic or abrasive detergents.
• Clean the casing with a slightly damp cloth.
• Clean the sole plate and the rest with a slightly damp cloth.
• Any residual water can remain in the water tank, but should
be poured out if it has been in the tank for a prolonged
period.
Troubleshooting
Fault Possible Cause
Faulty mains
Device does
not work
socket
Loud noises
during steam The tank is empty
operation
The scale filter
The "Descale" button
flashes and beeps.
cartridge is exhausted.
The appliance sud-
Is the electric circuit
denly malfunctions
overloaded?
during use
The temperature
Water leaks during
control on the iron is
steaming
set too low

Technical Specifications

Model: ...................................................................DBS 775 R CB
Power supply: ...........................................................230 V, 50 Hz
Power consumption: ......................................................... 2000 W
Protection class: ........................................................................... I
Maximum filling quantity of the water tank: .....................0.9 Liter
Net weight: ...........................................................................2.3 kg
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in
accordance with the latest safety regulations.
Remedy
Try another socket
Check the tank
See chapter "Scale
Filter" in this manual.
Check your fuses
Select a higher
temperature
31