Cold master MEDIKA 427 Installationsanleitung Seite 16

3. Remove magnet (counter-clockwise)
and place it in the opposing location on
the door frame.
6. Make sure how much of the
hinge pin is visible. This distance
must be maintained for the
reversed door
9. Move hinge pins to the opposite
site and fit the door by tightening
the hinge pins to top and bottom
of door. Ensure the distance
(see 6.) is strictly maintained.
BATTERY BACKUP SYSTEM AT START-UP
NOTE!
The battery backup system does not supply the
cooling system with power.
When starting up the appliance for the first time
it is necessary to switch on the battery backup system.
1. Open the door
2. Use a pen to switch on the battery backup system in
the hole shown on fig. 9
3. The switch will light green when the unit is powered
4. Close the door.
Lay the appliance
on its back.
7. Untighten and remove top
and bottom hinge pins by
turning them counter-clockwise.
10.Raise the appliance into upright
position. Ensure to hold firmly onto
the door while moving the appliance.
Align the door by adjusting the top
hinge pin and ensure the door is
securely locked and in place.
16
5. Open the top panel.
8. Rotate door 180° as shown
11. Remount lock and foot panel.
Please note: The 2 pins on the foot panel
must be fitted correctly in the dedicated
spaces (tilt the panel if needed and fix the
panel using the 2 screws).