Interior Fitting - Cold master MEDIKA 427 Installationsanleitung

Clean the inside of the cabinet using warm water with a mild detergent. Rinse with clean water
and dry thoroughly (see cleaning instructions). Use a soft cloth.
If during transport the appliance has been laid down, or if it has been stored in cold sur-
roundings (colder than +5°C), it must be allowed to stabilise in an upright position for at least
an hour before being switched on. Note: If the appliance is to be laid down, the door must face
upwards and the appliance must be enclosed in the original packaging.
PLACEMENT
For safety and operational reasons, the appliance must not be exposed to rain.
The appliance should be placed on a level surface in a dry, well ventilated room (max. 70%
relative air humidity). Never place the appliance close to sources of heat and avoid placing it in
direct sunlight. The surface on which the appliance is to be placed
must be level. Do not place on a frame or similar.
The appliance can be installed as a free-standing unit against a
wall or side-by-side with other appliances
MOVING THE UNIT
Unlock castors on all wheels.
Before moving the unit, ensure to close and lock the door.
When moving the unit, make sure to always face the glass
Fig. 1
door and hold firmly on the each side of the glassdoor as
showed above.
VENTILATION
Keep ventilation openings in the appliance enclosure or
in the built-in structure, clear of obstruction. The figures
below illustrate the clearance necessary to achieve the
required air circulation.
(Minimum 150 mm above) fig 2
LEVELLING THE APPLIANCE
It is important that the appliance is absolutely level.
If the appliance is placed on a soft surface, e.g. floorboards
or a carpet you must recheck whether the appliance is still
level after a period of time as the underlying surface may
yield under the weight of the appliance.
Some models have adjustment feets. (See fig 3)
SIDE BY SIDE
In side-by-side arrangements there must be
at least 25 mm between each unit on each
Fig. 2
side of the cabinets, to ensure the doors
can be opened freely

INTERIOR FITTING

Drawers
The drawers can be repositioned.
To remove the drawers the door must be
opened at least 90°.
Fig. 3
1.Remove drawer (See fig 5)
2.Remove and replace drawer brackets (See fig 6) in desired position.
14