helvi PC EVO 76 Bedienungsanleitung Seite 13

2
6
Figure 14
1. ON/FF Switch
In the ON position the machine is ready for normal
operation. All system control circuits are activated.
OFF position deactivates control circuits.
2. Output Current Knob (2)
Adjusts the cutting current supplied by the machine
according to application (thickness of material/
speed).
3. Display
It views the set cutting current when unit is on, during
pilot arc time views the pilot arc current and during
cutting views the cutting current.
It views the adjusted air pressure (bar) by pushing
the air drain key (B).
4. Control Panel
5. Air Regulator
It adjusts the input air pressure - pull outwards to
unlock. Note: push torch air purge key before acting
on the air regulator to get the air pressure displayed.
6. Earth cable connection (6)
7. Torch connection
8. Power cable
9. 14-Pin Male Connector
10. Compressed Air Connector
FUNCTIONS
3
1
4
5
7
EN-9
8 9
10