P.Lindberg NBM-105 Original Bedienungsanleitung Seite 90

Attaching the PTO shaft
1. Push the PTO shaft's end with the safety guard over the gearbox's shaft and secure
using the fixture.
2. Push the PTO shaft over the tractor's PTO shaft and secure using the PTO shaft's
locking unit.
3. Now move the PTO shaft forwards and backwards to check that it sits securely on the
tractor's PTO shaft and the flail mower's gearbox.
4. Connect the chain from the PTO shaft's guard to one of the top mounting brackets to
ensure that the guard does not rotate.
5. In case the PTO shaft must be shortened:
a) Hold the two halves next to one another in the shortest possible working
position and mark them off.
b) Shorten the inner and outer sheath tubes by the same distance.
c) Shorten the inner and outer slide runners to the same length as the sheath
tubes.
d) Correct overlap is at least half of the length of the tubes and both tubes should
be the same length.
e) Grind down all sharp edges and remove burrs. Lubricate the slide runners.
WARNING
The PTO guard and all guards must always be correctly and securely
attached before the flail mower is used.
P. Lindberg A/S
Tel.: +45 70212626
14
Sdr. Ringvej 1
6600 Vejen, Denmark
MAN 9063089 EN V1
www.p-lindberg.dk
E-mail: salg@p-lindberg.dk