Technical Specifications; Assembly, Installation And Commissioning - P.Lindberg NBM-105 Original Bedienungsanleitung

Technical specifications

Model
Dimensions
Weight
Side-shift (manual)
Working width
Flail type
Number of flails
Number of belts
PTO speed
Tractor power
requirements:

Assembly, installation and commissioning

A three-point hitch must be fitted.
Please refer to the exploded-view drawings.
Connecting to the tractor
1. Make sure that the tractor's towbar does not get in the way. Move it forward or
remove it if necessary. The towbar must also be checked for clearance when the
equipment is lifted for the first time.
2. Adjust the bottom lifting arms on the tractor for the flail mower's fork suspension.
Place the bottom hitch pins in the lowest turning joint and attach split pins.
3. Connect the tractor's top bar to the flail mower's top connection and secure using a
locking pin.
4. Adjust the top bar in or out to get the top hitch pin to be vertically above or slightly
behind the bottom hitch pins – to allow the flail mower to move. Operate the flail
mower with its rear end 15 degrees lower than the front end.
P. Lindberg A/S
Tel.: +45 70212626
NBM105
Total width: 1,265 mm
Depth/length: 1,059 mm
Total height: 804 mm
290 kg
150 mm
1,050 mm
Hammer flail
16
3
540 rpm
20 HP
13
Sdr. Ringvej 1
6600 Vejen, Denmark
MAN 9063089 EN V1
www.p-lindberg.dk
E-mail: salg@p-lindberg.dk