Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Manual instruction
Model: PB300-11
Functional elements list
1 Edge guide
2 Punching and binding lever
3 "Lock" button
4 Wire closing tray
5 Punching slot
6 Wire holder
7 Lid of waste bin
Set up for punching and binding
Take out the machine from the package box, the
punching lever is on "lock" position.
Press down the punching lever, and then move
"lock button" towards right end. So release the
punching lever to the top position.
Warning! Please don't operate the machine
when the lock button is in the "lock" position.
The "lock" button in the "lock" position is
only for storing.
Punching
Set edge guide to paper size you wish to bind
(see figure-3).
Align sheets and insert edge to be bound into
punching slot.
Jog the sheets until they are flush against the edge
guide and the bottom of the punching slot. Allow the
paper to rest against the Paper Support.
Press down the punching and binding lever.
Warning! Max. Punching capacity is 6 sheets
(80 gsm paper) per operation.
Binding
Place the wire element (6mm) into the Wire Holder
as shown in figure-4. Be sure it is firmly secured
with the small loops facing toward you.
6
Place your punched pages face up onto the small
loops of wire element. Then place your front and back
covers face-to-face against each other. Place the
covers onto the wire element with the front cover
first and the inside of theback cover facing upward.
This step ensures that after crimping the seam of
the wire element will be hidden between the back
cover and last page.
Hold the wire element firmly at each end of the book
and remove it from the wire holder by lifting it off.
While firmly holding the wire element and document
at one end place the book with the open end of the
wire face down into the wire closing tray. You can
release the book so it rests against the support rack.
To crimp the wire together pull the punching and
binding lever down toward you completely until it
goes no further. Remove the book and flip the front
cover around to the front. Your presentation is now
complete.
Note: only 6mm wire can be closed by this
machine!
Cleaning the waste chip
WARNING!! Be Sure to Clean Waste Bin
Frequently. Overloaded Waste Chips Could
Cause Punching Jam and Machine Damage.
You should upside the machine when you clean the
waste bin shown as fig-6.
Open the lid and empty the waste chip into dustbin,
then close the lid.
Werbung
