Beper 50.101 Anleitung Seite 8

Steam iron Use instructions
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
Some warnings
Always unplug the product when it is not in use, when filling or
emptying the tank.
Make sure that the power cord will not come in contact with hot parts
of the iron.
Don't leave the iron unattended while it is on.
Before first use
At the first use, the iron could emit some smoke, this is normal and does not compromise the functioning of the
product.
Before using the product for the first time, remove the protective film from the plate and clean it with a soft cloth.
Use
Always check the label with the ironing instructions on the article to be ironed and follow them.
Turn the thermostat knob to set the desired temperature, following the legend below.
Symbol Fabric
Do not iron
Synthetics, nylon, acrylic, and polyester cloths
Wool, Silk
Cotton and linen cloths
Insert the plug into the socket. The operating light will turn on.
When the light switches off, it will be possible to start ironing.
It is recommended to wait until the light switches off before starting ironing.
We recommend to set first a low temperature and then switch to a higher one.
8