Beper 50.101 Anleitung Seite 10

Steam iron Use instructions
The boiling water, the steam and the impurities will be expelled from the holes in the plate.
Unplug the power cord from the power outlet.
Wait until the iron is cold before storing it.
Anti-calc system
A special resin filter inside the water tank softens the water and prevents limescale build-up in the plate. The
resin filter is permanent and does not require replacement.
Note: Do not use chemical additives, scented substances or descaling agents. Failure to comply with the
above mentioned regulations will make a loss of the warranty.
Anti-drop system
With the anti-drop system, even the most delicate fabrics can be ironed perfectly and it is recommended to
always iron at low temperatures.
The plate can cool down to the point where no more steam will come out, but drops of boiling water may come
out and may leave marks or stains. In this case, the anti-drip system is activated automatically to prevent vapo-
rization, so you can iron the most delicate fabrics without risking to damage or stain them.
Storage
Unplug the power cord from the power outlet, empty the water tank (do it after each use) and allow the iron to
cool completely.
Wrap the cord around the base.
To protect the plate, place the iron in an upright position.
Technical data
Power: 2200W
Power supply: 220-240V ~ 50-60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
10