KKT KOLBE GSI62ED Benutzerhandbuch Seite 73

Troubleshooting
Problem
Foam in in the drain.
Spots on the inner
wall of indulgences.
The dishes are not
quite dry.
The dishes and the
pans are not clean.
Spots and streaks on
the lenses and the
pans.
Steam.
Black or gray spots
on the plates.
Water on the bot-
tom, inside of the
device.
Leaks in the dish-
washer machine.
Possible causes
Poured rinse aid.
There was a washing-up
liquid with dye.
The rinse aid dispenser is
empty.
Wrong program.
Incorrect insert.
• Extremely hard water
• Low input temperature
• Incorrect insert
• Wrong detergent
• Wrong this salt / deter-
gent degree
Normal appearance.
The rubber on the alumi-
num cutlery touches the
plate.
Normal appearance.
The detergent dispenser
is filled or it came to the
pouring of the detergent
into the interior of the
device.
The dishwasher is not
balanced.
Help
Excess or poured out rinse aid always imme-
diately wipe.
Use detergent without dye.
Fill up on this.
Select a more intensive wash program.
Make sure that the spray arms and the de-
tergent dispenser are covered with no great
dish pieces.
See related sections of this manual for the
determination of whether the detergent,
salt and detergent levels are fine. Verify
whether the dishes are loaded properly.
The drying and draining of water can result
in the leakage of a small amount of steam in
the vicinity of the door latch.
To eliminate these stains, use a medium-
abrasive cleaners. In the future, you always
make sure that the harness is correctly
inserted.
A small amount of water on the floor of the
unit is normal.
Do not over fill the detergent dispenser.
The poured detergent may cause excessive
foaming and overflowing. Wipe all poured
liquids immediately with a damp cloth.
Make sure that the dishwasher is horizontal
and is balanced.
73