Filter Clearning; Cleaning The Spray Arms - KKT KOLBE GSI62ED Benutzerhandbuch

Maintenance and cleaning
6.1 Filter cleaning
To achieve the highest efficiency and best results, the entire
filter unit is always thoroughly and regularly (ideally after each
wash cycle) to clean.
1. Turn the coarse filter counterclockwise and pull it in the
direction upwards. Rinse this part under running water and
remove all food residues that have attached themselves to
the filter.
2. Pull the main filter out and rinse it off under running water to
remove all food residues that have been attached to the filter.
3. Pull out the fine filter and rinse it off under running water to
remove all food residues that have been attached to the filter.
4. Remove the fine filter back in.
5. Remove the main and coarse filter back into the space
provided in the base of the dishwasher one. The coarse filter
must be turned in a clockwise direction, so that it locks in the
correct position.
If dish breaks in the device, make sure that all fragments
!
were removed before the machine is started again, so as not
to damage the unit.
Never turn on the wash cycle when the filters are
not installed!

6.2 Cleaning the spray arms

The spray arms should be cleaned regularly to avoid clogging
of the nozzles in the spray arms and the bearing with hard
water deposits.
• To remove the spray arm, first unscrew the nut and remove
the washer, which is placed on the upper part of the spray
arm.
68