Installing The Appliance - Blaupunkt 5GB 61150 Montage- Und Gebrauchsanweisungen

Installing the appliance

Bottom view
(A) SEALING STRIP
(C) SCREW
1. Remove the pan supports, the burner lid and
2. Apply the sponge provided around the edge
3. Do not leave a gap in the sealing agent or
1. Place the bracket (B) over the holes that match the
2. Carefully turn the hob back over and then gently
3. On the underneath of the hob, adjust the brackets
(B) BRACKET
flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
Take care that the Ignition devices and flame
supervision devices are not damaged in this
operation.
of the appliance.
overlap the thickness.
Sponge
The thickness of the sponge is 3 mm.
The width of the sponge is 10 mm.
Do not use a silicon sealant to seal the
appliance against the aperture.
This will make it difficult to remove the
appliance from the aperture in future,
particularly if it needs to be serviced.
size of the screws. There are one set of screw
holes in each corner of the hob (H).
Slightly tighten a screw (C) through the bracket (B)
so that the bracket is attached to the hob, but so
that you can still adjust the position.
lower it into the aperture hole that you have cut out.
into a position that is suitable for your worktop.
Then fully tighten the screws (C) to secure the hob
into position.
38