Installing The Appliance - Blaupunkt 5GB 62190 Montage- Und Gebrauchsanweisungen

Installing the appliance

Bottom view
(A) SEALING STRIP
(C) SCREW
1. Remove the pan supports, the burner lid and flame
2. Apply the sponge provided around the edge of the
3.
1. Place the bracket (B) over the holes that match the size
of the screws. There are one set of screw holes in each
corner of the hob (H) .
Slightly tighten a screw (C) through the bracket (B) so
that the bracket is attached to the hob, but so that you
can still adjust the position .
2. Carefully turn the hob back over and then gently lower it
into the aperture hole that you have cut out.
3. On the underneath of the hob, adjust the brackets into a
position that is suitable for your worktop.
Then fully tighten the screws (C) to secure the hob into
(B) BRACKET
position.
spreader and carefully turn the appliance upside
down and place it on a cushioned mat.
Take care that the Ignition devices and flame
supervision devices are not damaged in this
operation.
appliance.
Do not leave a gap in the sealing agent or overlap the
thickness.
Sponge
The thickness of the sponge is 3 mm. The width
of the sponge is 10 mm.
Do not use a silicon sealant to seal the
appliance against the aperture.
This will make it difficult to remove the
appliance from the aperture in future,
particularly if it needs to be serviced.
38