Blaupunkt 5GB 61150 Montage- Und Gebrauchsanweisungen Seite 32

How to Use the appliance
Automatic ignition with flame failure safety device
The appliance is fitted with a flame failure safety device on each burner, which is designed
to stop the flow of gas to the burner head in the event of the flame going out.
To ignite a burner:
Press in the control knob of the burner that you wish to light and turn it anti-clockwise
o
to the maximum position.
If you keep the control knob depressed, the automatic ignition for the burner will
o
operate.
You should hold down the control knob for 15 seconds after the flame on the burner
o
has lit. If after 15s the burner has not lit, stop operating the device and open the
compartment door and/or wait at least 1 min before attempting a further ignition of the
burner.
After this 15-second interval, to regulate the flame you should continue turning the
o
control knob anti-clockwise until the flame is at a suitable level. The operating position
MUST be at a position between the maximum and minimum position.
To switch the burner off, turn the control knob fully clockwise to the gas off position.
o
In case of power failure, the burners can be lit by carefully using a match.
o
32