Installing An Optical Drive - Asus T3-M2NC51PV Schnellinstallationsanleitung

Installing a SATA hard disk drive
1. Connect the SATA power
cable to the plug of the power
supply unit.
2. Connect the SATA signal cable
and the power plugs to the
connectors at the back of the
drive.
3. Locate the HDD tray.
4. Insert a hard disk drive (with
the HDD PCB facing the top of
the chassis) to the tray, then
secure it with four screws.
5. Connect the SATA signal cable
to the SATA connector on the
motherboard, and tighten all the
cables with the plastic coils.

Installing an optical drive

1. Place the chassis upright.
2. Insert the optical drive to the
upper 5.25 in drive bay, then
carefully push the drive until
its screw holes align with the
holes on the bay.
3. Secure the optical drive with
four screws on both sides of
the bay.
4. Connect the IDE and the power
plugs to the connectors at the
back of the drive.
2
1
4
4
4
4
4
2
3
2
3
vii