Bosch GWI 10,8 V-LI Professional Originalbetriebsanleitung Seite 17

OBJ_BUCH-134-006.book Page 17 Wednesday, June 11, 2008 2:39 PM
Technical Data
Cordless angle drill/driver
Article number
Rated voltage
No-load speed
Max. torque for
hard/soft screwdriving
application according to
ISO 5393
Torque adjustment
range
Max. screw dia.
Max. drilling dia.
– Steel
– Wood
Weight according to
EPTA-Procedure
01/2003
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Noise/Vibration Information
Measured values determined according to
EN 60745.
Typically the A-weighted sound pressure level of
the product is less than 70 dB(A). Uncertainty
K =3 dB.
The noise level when working can exceed
80 dB(A).
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Drilling into metal: Vibration emission value
2
a =2.5 m/s , Uncertainty K =1.5 m/s
h
Screwdriving: Vibration emission value
2
a =2.5 m/s , Uncertainty K =1.5 m/s
h
The vibration emission level given in this informa-
tion sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another. It
may be used for a preliminary assessment of ex-
posure.
Bosch Power Tools
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with differ-
GWI 10,8 V-LI
ent accessories or poorly maintained, the vibra-
Professional
tion emission may differ. This may significantly
3 601 C60 U..
increase the exposure level over the total work-
ing period.
V= 10.8
An estimation of the level of exposure to vibra-
rpm 0 – 585
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total
Nm 13/5 working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
Nm 2.6 – 5.2
maintain the tool and the accessories, keep the
mm 5
hands warm, organisation of work patterns.
Declaration of Conformity
mm 8
mm 10
We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
kg 1.1
to the provisions of the directives 2004/108/EC,
98/37/EC (until 28 Dec 2009), 2006/42/EC
(from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
05.05.2008, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly
2
,
2
.
Battery Charging (see figure A)
Dr. Eckerhard Strötgen
Head of Product
Certification
Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
1 609 929 R97 | (11.6.08)
English | 17