Functional Description; Intended Use; Product Features - Bosch GWI 10,8 V-LI Professional Originalbetriebsanleitung

OBJ_BUCH-134-006.book Page 16 Wednesday, June 11, 2008 2:39 PM
16 | English
Hold power tool by the insulated gripping
surfaces, when performing an operation
where the cutting tool may run into hidden
wiring. Contact with a "live" wire will make
exposed metal parts of the tool "live" and
shock the operator.
Hold the machine with a firm grip. High reac-
tion torque can briefly occur while driving in
and loosening screws.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to a
complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Avoid unintentional switching on. Ensure the
On/Off switch is in the off position before in-
serting battery pack. Carrying the power tool
with your finger on the On/Off switch or in-
serting the battery pack into power tools that
have the switch on invites accidents.
Do not open the battery. Danger of short-
circuiting.
Protect the battery against heat, e. g., al-
so against continuous sun irradiation and
fire. There is danger of explosion.
In case of damage and improper use of the
battery, vapours may be emitted. Provide for
fresh air and seek medical help in case of
complaints. The vapours can irritate the respi-
ratory system.
When the battery is defective, liquid can es-
cape and come into contact with adjacent
components. Check any parts concerned.
Clean such parts or replace them, if required.
Use the battery only in conjunction with your
Bosch power tool. This measure alone pro-
tects the battery against dangerous overload.
1 609 929 R97 | (11.6.08)

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may result
in electric shock, fire and/or serious
injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.

Intended Use

The machine is intended for driving in and loos-
ening screws as well as for drilling in wood, met-
al, ceramic and plastic, especially at hard to
reach locations.

Product Features

The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Locking sleeve
2 Tool holder
3 Screwdriver bit*
4 Rotational direction switch
5 On/Off switch
6 Torque selector switch
7 Release button for angle selection of drill
head
8 Utility clip
9 Battery unlocking button
10 Battery
11 Drill bit with hexagon shank*
12 Universal bit holder*
*The accessories illustrated or described are not in-
cluded as standard delivery.
Bosch Power Tools