AEG HK654070IB Benutzerinformation Seite 15

Problem
Residual heat indicator does
not come on.
Automatic Heat Up does not
operate.
You cannot activate the out-
er ring.
There is a dark area on
the multiple zone.
The sensor fields become
hot.
There is no sound when you
touch the panel sensor
fields.
comes on.
and a number come on.
You can hear a constant
beep noise.
comes on.
Possible cause
The zone is not hot because
it operated only for a short
time or the sensor is dam-
aged.
The zone is hot.
The highest heat setting is
set.
It is normal that there is a
dark area on the multiple
zone.
The cookware is too large or
you put it too near to the
controls.
The sounds are deactivated.
Child Safety Device or Lock
operates.
There is an error in the hob.
The electrical connection is
incorrect.
The second phase of the
power supply is missing.
ENGLISH
Remedy
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the func-
tion.
First, activate the inner ring
by changing the heat set-
ting.
Put large cookware on the
rear zones if possible.
Activate the sounds. Refer to
"Daily use".
Refer to "Daily use".
Deactivate the hob and acti-
vate it again after 30 sec-
onds. If comes on again,
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin-
ues, speak to an Authorised
Service Centre.
Disconnect the hob from the
electrical supply. Ask a quali-
fied electrician to check the
installation.
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse,
wait one minute, and insert
the fuse again.
15