Velleman CCTVPROM7 Bedienungsanleitung Seite 9

Configure
Password
Date & Time
Default configuration
• Click OK to restart the DVR.
Reset
• Show system information e.g. hardware and software versions.
About
14/07/2010
CCTVPROM7
• Select the 'Video Loss' option to get an audible
warning when one of the video signals is lost.
• The AutoSwitch timer set the timer interval of the
sequential view mode. Value: 1~99s.
• PIPConfig sets the Picture-in-Picture settings. The first
channel is the inserted picture, the second channel is
the main (background) picture.
• Select the VGA resolution settings: 1024x768/60Hz,
1280x1024/60Hz or 800x600/75Hz.
• Enable or disable password protection. Set the
password via the password menu.
• LockTime is the timeout for the password to become
active. When no user activity is detected during locking
time, a password will be required to operate the DVR.
Set to 1, 2, 5, 10, 15 or 30 minutes or 1 hour. Setting
will only take effect when password is enabled.
• To change the password, first enter the old password.
Default password is 888888.
• Enter a new password. Only use the numbers on the
bottom of the screen.
• Confirm the new password and press OK.
• Set the date and time of the DVR. Date format is month
– day – year (MM-DD-YYYY), time format: hours –
minutes – seconds.
Note: changing the time is not possible during
recording.
• When finished, click OK to save or CANCEL to exit
without saving.
Note: reset the system (see below) for the new
date/time to take effect.
• Click OK to set the DVR back to factory defaults.
9 ©Velleman nv