Rating Data; Operating Conditions - Beveltools Bevel Mite EBI-06 Betriebsanleitung

2.2.1 Turn on
• Make sure you always have a firm footing when working with the machine.
• Whatever the position of the machine, always use two hands to control the machine.
• Never touch the milling head when the machine is running.
• Never use the machine above head height.
• The machine should only be used for conventional up‐cut milling.
• To turn the machine on, push the ON/OFF switch toward the front.
• Bring the machine slowly into contact with the work piece only after the selected tool speed has
been reached.
• When cutting a bevel always move the machine from left to right against the direction of rotation
of the milling head.
• When machining bore holes, always work in a clockwise direction.
2.2.2 Turn off
• Take Beveling machine from work peace and turn off.
• Motor stops.

2.3 Rating data

Power voltage (cf. replacement parts list)
Power Input
Power Output
No-load speed
Max. wheel diameter
Grinding spindle thread
Sound pressure level according to EN 60745
Noise emission level
Vibration according to EN 60745
Weight w/o cord set
Protection class
The specified vibration value was measured with a standardized test procedure. It can be used to
compare products or to make an initial assessment of the exposure. The vibration emissions may
differ from the specified value, depending on how the power tool is used. Operating personnel must
be protected with defined safety measures based on the estimated exposure under the actual
conditions of use (these must take into account all phases of the operating cycle, e.g. the times
when the power tool is switched OFF and the times it is switched ON, but is not under load).

2.4 Operating conditions

Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
120/230V; 50/60 Hz; 120/230V
500 W
400 W
11000 min-1/rpm
24 mm
M6
89 dB (A) K = 3 dB
100 dB (A) K = 3 dB
5.2 m/s2 K = 1.5m/s2
1.6 kg
/ II
5