AEG A62700HLW0 Benutzerinformation Seite 28

28
What to do if...
Problem
The lid doesn't close com-
pletely.
The lid is difficult to open. The lid gaskets are dirty or sticky. Clean the lid gaskets.
The lamp does not work.
It is too warm in the freez-
er.
It is too cold inside the
freezer.
The appliance does not
work at all. Neither cool-
ing nor lighting works.
Possible cause
The lid is not shut properly or
do not close tightly.
The temperature is not set cor-
rectly.
The water drainage plug is not
correctly positioned.
There is excessive frost.
The lid gaskets are dirty or sticky. Clean the lid gaskets.
Food packages are blocking the
lid.
The valve is blocked.
The lamp is defective.
The temperature is not set cor-
rectly.
The lid does not close tightly or
it is not shut properly.
Before freezing the appliance
was not precooled sufficiently.
Large quantities of food to be
frozen were put in at the same
time.
Food placed in the appliance
was too warm.
Products to be frozen are
placed too closely to each other.
The lid has been opened often.
The lid has been opened for a
long time.
The temperature is not set cor-
rectly.
Plug is not connected to the
mains socket properly.
Solution
Check if the lid closes well and
the gaskets are undamaged and
clean.
Set a warmer temperature.
Position the water drainage plug
in the correct way.
Eliminate excess frost.
Arrange the packages in the
right way, see the sticker in the
appliance.
Check the valve.
Refer to "Replacing the lamp".
Set a lower temperature.
Check if the lid closes well and
the gasket is undamaged and
clean.
Pre-cool the appliance for
enough time.
Wait some hours and then check
the temperature again. Next
time insert smaller quantities of
food to be frozen at any one time.
Allow food to cool to room tem-
perature before storing.
Place the products in a way so
that cold air could circulate
among them.
Try to not open the lid often.
Do not leave the lid open longer
than necessary.
Set a warmer temperature.
Connect the mains plug properly.