Werbung
Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1
Flush through the supply pipes.
2
Place the mixer including the sealing
washer in position on the basin / bidet.
3
Slide the fixation piece including the washer
over the threaded pins and tighten the nuts.
4
Connect the supply pipes to the isolation
valves; cold right - hot left.
5
33001000/32002XXX/33200XXX/
33202XXX: Connect the pull rod to the pop-
up waste.
The hot and cold supplies must be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
This mixer series-produced with
waterdimmer® (flow limiter).
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Recommended hot water temp.:
Recommended hot water temp.:
6
English
7 l/min 0,3 MPa
12 l/min 0,3 MPa
max. 1 MPa
0,1 – 0,5
1,6 MPa
max 80° C
60° C
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
If the continuous water heater causes any
problems or there is not enough flow of water,
the waterdimmer® (5a) located behind the
aerator must be removed.
To adjust the hot water limiter on single lever
mixers, please see page 8.
No adjustment is necessary when using a
continuous flow water heater.
Spare parts see page 5
1
handle
1.1 screw cover
2
flange
Cap, gold
3
nut
4
cartridge cpl.
5
aerator cpl. (10)
aerator cpl. gold
aerator cpl. (6 l/min)
6
pull rod
pull rod gold plated
7
fixing set
8
connection hose
9
connection hose
Special accessories
X special tool set 58085000
(order as an extra)
33091000
94191000
94192000
94192990
94194000
92730000
13912000
94980990
96788000
92620000
92620990
96016000
95001000
97206000
Werbung
