Display Window - CARE FITNESS MED 2040 AeroMagnetic Bedienungsanleitung

2. Insert 2 AAA batteries into the battery compartment and reinstall the battery cover.
3. When Battery working voltage is too low, The "Low battery" indicator will show up on the console display indicating it
is time to change the batteries.
Speed Sensor Transmitter Battery Installation
1. Remove the battery cover from the transmitter.
2. Install 2 AAA batteries in the battery compartment and reinstall the battery cover.
3. When new batteries are installed in the transmitter or console you must perform the synchronizing procedure below
for the console to work properly
Console Installation:
Insert console into the bracket of handle bar.
The speed transmitter and Magnet were already installed on fork and belt wheel.

DISPLAY WINDOW

TIME
Time is measured in min:sec
There is a time of day clock and a workout timer clock.
The workout time will count up or count down during pedaling. If pedaling stops, the time will stop counting after 3
seconds.
RPM/CADENCE
Cadence is the measurement of how fast the cranks are rotating in RPM. The approximate speed of the bike can also
be display in MPH or KMH.
In addition to the MPH/KMH, the RPM section of the display also has a bar graph that allows the rider to visually keep
track of the approximate RPM.
DISTANCE
Distance is the measurement of the virtual distance traveled on the bike. This distance is based on the user riding a
bike with tires that are the same size as the bike's flywheel.
KCAL
Kcal is the approximation of calories burned during your work out. The calories are an estimate only.
HEART RATE (optional)
This the approximation of heart rate detected from the chest belt during your work out.
QUICK Start
When the console is in Power Saving Mode, hold down any key to wake up the console and go to the start-up screen,
also called "QUICK Start" active state.
Power Saving Mode QUICK START Mode