Technical Data; Intended Use - Bosch AKE 30 S Bedienungsanleitung

Cut wood only. Don't use chain saw for pur-
poses not intended – for example – Don't use
chain saw for cutting plastic, masonry or non-
wood building materials. Use of the chain saw
for operations different then intended could result
in a hazardous situation.
Causes and Operator Prevention of Kickback:
– Kickback may occur when the nose or tip of the
guide bar touches an object, or when the wood
closes in and pinches the saw chain in the cut.
– Tip contact in some cases may cause a sudden
reverse reaction, kicking the guide bar up and
back towards the operator.
– Pinching the saw chain along the top of the guide
bar may push the guide bar rapidly back towards
the operator.
– Either of these reactions may cause you to lose
control of the saw which could result in serious
personal injury. Do not rely exclusively upon the
safety devices built into your saw. As a chain saw
user, you should take several steps to keep your
cutting jobs free from accident or injury.

Technical data

Chain saw
Part number (typ)
Rated power
Chain speed (no load)
Chain bar length
Tool-less chain
tensioning (SDS)
Nose sprocket
Kickback Brake
Chain type
Drive link thickness
Amount of drive links
Oil reservoir capacity
Automatic oiler
Metal gripping teeth
Weight without mains cable.
approx. **
Protection class
**measured with chain bar and chain
Note: Please observe the order number of your machine. The trade names of individual machines can vary.
Inrush currents cause short-time voltage drops. Under unfavourable power supply conditions, other equipment may be af-
fected. If the system impedance of the power supply is lower than 0.25 Ohm, disturbances are unlikely to occur.

Intended Use

The chain saw is intended for sawing of trees, tree
trunks, branches, wooden beams, planks, etc. Cuts
can be sawed with or across the grain. This product
is not suitable for sawing mineral materials.
20 • F 016 L70 540• TMS • 29.01.09
AKE 30 S
3 600 H34 4..
[W] 1800
[m/s] 9
[cm] 30
–
3/8" - 90
[mm] 1.1 (0.043")
45
[ml] 200
[kg] 3.9
/ II
English - 3
Kickback is the result of tool misuse and/or incorrect
operating procedures or conditions and can be
avoided by taking proper precautions as given be-
low:
Maintain a firm grip, with thumbs and fingers
encircling the chain saw handles, with both
hands on the saw and position your body and
arm to allow you to resist kickback forces.
Kickback forces can be controlled by the opera-
tor, if proper precautions are taken. Do not let go
of the chain saw.
Do not over reach and do not cut above shoul-
der height. This helps prevent unintended tip
contact and enables better control of the chain
saw in unexpected situations.
Only use replacement bars and chains speci-
fied by the manufacturer. Incorrect replacement
bars and chains may cause chain breakage and/
or kickback.
Follow the manufacturer's sharpening and
maintenance instructions for the saw chain.
Decreasing the depth gauge height can lead to in-
AKE 35 S
3 600 H34 5..
1800
9
35
3/8" - 90
1.1 (0.043")
52
200
4.0
/ II
Introduction
This manual gives instructions on the correct as-
sembly and safe use of your chain saw. It is impor-
tant that you read these instructions carefully.
AKE 40 S
3 600 H34 6..
1800
9
40
3/8" - 90
1.1 (0.043")
57
200
4.1
/ II