AEG AIK2223R Benutzerinformation Seite 50

50 www.aeg.com
Problem
The compressor does not
start immediately after
pressing the ,COOLMATIC
or after changing the tem-
perature.
Water flows on the rear plate
of the refrigerator.
Water flows into the refriger-
ator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
All manuals and user guides at all-guides.com
Possible cause
The COOLMATIC function is
switched on.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost melts
on the rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The COOLMATIC function is
switched on.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The COOLMATIC function is
switched on.
There is no cold air circula-
tion in the appliance.
Solution
Refer to "COOLMATIC func-
tion".
The compressor starts after a
period of time.
This is correct.
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Switch off COOLMATIC
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "COOLMATIC function".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
Refer to "COOLMATIC func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.