Important Safeguards & Warnings - Technaxx TX-49 Bedienungsanleitung

4 Important Safeguards & Warnings
4.1 Electrical safety: All installation and operation here should conform to your local
electrical safety codes. The power shall conform to the requirement in the SELV (Safety
Extra Low Voltage) and the Limited power source is rated 12V DC (24V AC) in the
IEC60950-1. We assume no liability or responsibility for all the fires or electrical shock
caused by improper handling or installation.
4.2 Transportation security: Heavy stress, violent vibration or water splash are not
allowed during transportation, storage and installation.
4.3 Installation: Do not apply power to the camera before completing installation. Install
the proper power cut-off device during the installation connection. Always follow the
instruction guide the manufacturer recommended.
If this product is installed in the ceiling, make sure the installation position can sustain
the min 50N.
4.4 Qualified engineers needed: All the examination and repair work should be done
by the qualified service engineers. We are not liable for any problems caused by
unauthorized modifications or attempted repair.
4.5 Environment: This series camera should be installed in a cool, dry place away from
direct sunlight or strong light, inflammable, explosive substances and etc. This series
camera shall work on the specified working temperature. Keep it away from the
electromagnetic radiation object and environment. Keep the sound ventilation. Do not
allow the water and other liquid falling into the camera.
4.6 Accessories: Be sure to use all the accessories recommended by manufacturer.
Before installation, open the package and check all the components are included.
Contact your local retailer ASAP if something is broken in your package.
4.7 Maintenance: Shut down the device and then unplug the power cable. Use the dry
soft cloth to clean the device. If there is too much dust, use the water to dilute the mild
detergent first and then use it to clean the device. Finally use the dry cloth to clean the
device. Put the dustproof cap to protect the CCD (CMOS) component when you do not
use the camera.
9