Concept VI1030 Bedienungsanleitung Seite 48

WARNING!
• After cooking has finished, there is residual heat in the glass-ceramic plate coming from the cooking utensil. Pay extra
attention as the heat zone is hot and you can be burnt. This residual heat can be utilised.
• The touch control is activated by placing a finger on the required symbol on the glass-ceramic plate. Therefore, keep
the control panel clean and dry.
• The control panel must be kept clean and dry.
• Make sure the appliance is prevented from being accidentally switched on, e.g. by kids or pets.
• When the hob is disconnected from the mains, the set-up parameters are reset.
Prior to first use
Prior to operating a new appliance for the first time, wipe the top glass-ceramic plate with a wet cloth.
1. Place the appliance on a stable, heat-resistant surface away from other heat sources.
2. Unwind the entire supply cable. Make sure it is not in contact with any heat sources nearby. Insert the plug into the
electric voltage outlet.
3. Check to ensure that the surrounding of the air inlet/outlet grids are open and that there is no danger of the grids
clogging or sucking in an object.
4. Remove small metal items from the surroundings of the appliance; they can become hot or magnetised.
5. Place the cooking utensil containing food in the centre of the heat zone. Use a utensil with a diameter of 120 to
260 mm (210 mm is the best). The safety fuse prevents utensils with a diameter less than 120 mm from heating to
avoid the unwanted heating of other metallic items, such as nearby cutlery, spoons, and other items.
6. To switch on the hob, press the ON/OFF symbol (1). If you do not make a further selection within 1 minute, the hob
automatically switches off.
7. Set the power grade of the cooking zone by pressing the power selection symbol (5) repeatedly, until the desired
function is selected.
Unit functions:
a) +/- function selection and subsequent regulation using + and – buttons (3) provides for power control from min
200W up to max 2000 W
b) WATER preset function at 2000 W
c) STEAM preset function at 1600 W
d) KEEP WARM preset function at 80°C
e) MILK preset function at 800 W
f) RICE preset function at 1000 W
8. After you finish cooking by pressing the ON/OFF symbol (1), switch off the hob.
Note: After the hob is off, residual heat in the glass-ceramic plate comes from the cooking utensil. Take extra care as
the hob is hot and you can be burnt (symbol „ H" - hot). This residual heat can be utilised.
9. The cooling fan may continue to operate for several minutes in order to cool the internal electronics. Wait until the
cooling fan switches off automatically!
10. Disconnect the appliance from the power supply.
Cooking zone functions of delayed switch-off and delayed start
The delayed switch-off function can only be selected in combination with +/- function enabling power control (max
180 min).
46
EN
VI1030