Technical Data - Niko 350-20058 Handbuch

350-20058 / 350-20158
4. MAINTENANCE
Dirt and grime may prevent the outdoor motion detector from functioning properly. For that reason, always keep the lens clean
and dry. Use a damp cloth and water with some detergent to clean the lens. Never exert pressure to wipe the lens clean. Replace
the outdoor motion detector if the lens or other parts of the outdoor motion detector are faulty.
5. TROUBLESHOOTING
Problem
The outdoor motion detector is not
activated.
No / little detection during the walking
test.

6. TECHNICAL DATA

Dimensions:
Power supply voltage:
Power consumption:
Relay contact:
Maximum load:
Maximum switching capacity
Maximum inrush current:
Detection angle:
Mounting height:
Detection range (at a height of 2.5 m):
Light sensitivity:
Switch-off delay:
Protection degree:
Protection class:
Ambient temperature:
Cabling:
Cable inlet:
Quality marks:
EN
Cause
The outdoor motion detector is
connected incorrectly.
The outdoor motion detector is placed
incorrectly.
The lens is covered, dirty or defective.
125 x 72 x 63 mm (HxWxD)
230 Vac ± 10%, 50 Hz
0.25 W
NO (max. 10 A), light- and motion-sensitive
incandescent lamps (2,300 W)
230 V halogen lamps (2,300 W)
all low-voltage halogen lamps (2,300 VA)
fluorescent lamps (non-compensated) (1,200 VA)
economy lamps (CFLi) (1,200 VA)
140 µF
80 A/20 ms
180°
2 – 3 m
semicircular, up to max. 13 m (350-20158)
semicircular, up to max. 16 m (350-20058)
5 lux - infinity
1 min – 30 min
IP54
class II devices
-20 - + 45 °C
3 x 1.5 mm²
2 x 12.5 mm
CE marked in accordance with EN 60669-2-1
Solution
Connect the outdoor motion detector
as described in the manual.
Mount the outdoor motion detector as
described in the manual.
- Remove the cover and/or clean the
lens.
- If the lens is defective, the sensor
must be replaced.
19