Installation Tips - Niko 350-20058 Handbuch

350-20058 / 350-20158
Read the complete manual before carrying out the installation and activating the system.
1. DESCRIPTION
The motion detector uses Passive Infrared Technology (PIR) and is suitable for outdoor use. Lighting control using motion
detection is useful for driveways, gardens, houses, holiday homes, car parks and public places.
The outdoor motion detector is available in two versions: White (350-20058) and Anthracite (350-20158).
2. INSTALLATION
2.1. Placement
The outdoor motion detector reacts to motion and heat in its environment. It is most sensitive to diagonal movement (walking
direction) with respect to the detection beam (fig. 1).

Installation tips:

- The recommended mounting height is 2 to 3 m. At a height of 2.5 m, the White outdoor motion detector has a maximum
detection range of 14 m at a detection angle of 180°.
Please note: The maximum detection range of the Anthracite outdoor motion detector is 11 m at a height of 2.5 m.
- Install the outdoor motion detector away from moving objects (such as tree branches and leaves), heat sources or air currents.
This can result in undesired activation of the outdoor motion detector.
- Do not position the outdoor motion detector towards the light source it is meant to activate.
Please note: Do not install the outdoor motion detector while it is connected to the mains voltage. Do not connect the device
to the mains voltage until installation is complete.
2.2. Mounting
Opening the outdoor motion detector (fig. 2)
A. Insert a screwdriver into the opening at the bottom of the outdoor motion detector. Open the locks on the cover using a
screwdriver.
B. Click the cover off.
Mounting and connecting the outdoor motion detector (fig. 2)
C. Ensure the arrows on the sensor portion and the motion detector housing are pointing in opposite directions.
D. Pull on the top of the sensor portion.
E. Release the clamp on the bottom.
F. Remove the sensor portion.
G. Pass the cable through the opening in the bottom of the housing and attach the unit to the wall. Connect the sensor (fig.
3.1).
Install a push button if manual operation of the outdoor motion detector is also desired (fig. 3.2).
H. Mount the assembly by placing the sensor portion back onto the bottom of the housing. Pay attention to the direction of
the arrows.
I. Hook the cover over the top and click it onto the sensor portion.
16 EN