Makita DFL083F Betriebsanleitung Seite 9

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Selecting correct socket
There are different types of sockets for some models depending on
applications. Choose and install a correct socket for your application.
Installing or removing socket
► Fig.12: 1. Socket 2. Hole 3. Pin
To install the socket, push it onto the square drive of the tool
with one hand by depressing a pin on the square drive with
another hand until it locks into place. To remove the socket,
simply pull it off depressing the pin on the square drive.
CAUTION:
Before operation, make sure that
the socket is properly locked onto the square drive.
Incomplete attachment of the socket may cause injury.
Installing hook
Optional accessory
The hook is useful to hang the tool. Install the hook to
the holes on the tool body.
► Fig.13: 1. Hook 2. Hole
OPERATION
Hold the tool firmly and place the socket over the bolt or nut.
Then switch the tool on. When the clutch cuts in, the motor
will stop automatically. Then release the switch trigger.
NOTE: Hold the tool with its square drive pointed straight
at the bolt or nut, or the bolt or nut will be damaged.
Limits of fastening capacity
Use the tool within the limits of fastening capacity. If you
use the tool beyond the limits, the clutch does not work.
And the tool cannot deliver enough fastening torque.
For model DFL083F
360°
300°
240°
2
180°
120°
60°
30°
2 3 4
1. Range of fastening capacity 2. Rotation angle
3. Torque
1
5 6 7 8
3
N•m
For model DFL125F
360°
300°
240°
2
180°
120°
60°
30°
5 6
1. Range of fastening capacity 2. Rotation angle
3. Torque
For model DFL204F
360°
300°
240°
2
180°
120°
60°
30°
10
8
1. Range of fastening capacity 2. Rotation angle
3. Torque
For model DFL302F
360°
300°
240°
2
180°
120°
60°
30°
16
1. Range of fastening capacity 2. Rotation angle
3. Torque
9 ENGLISH
1
7 8 9 10
3
N•m
1
12 14 16 18
3
N•m
1
20 25
3
N•m
11 12
20
30