Functional Description - Makita 9032 Bedienungsanleitung

5. Always use safety glasses or goggles. Ordinary
eye or sun glasses are NOT safety glasses.
Hold the tool firmly with both hands.
6.
7. Make sure the belt is not contacting the work-
piece before the switch is turned on.
8. Keep hands away from rotating parts.
Do not leave the tool running. Operate the tool
9.
only when hand-held.
10. This tool has not been waterproofed, so do not
use water on the workpiece surface.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Adjusting arm inclination
The arm can be pivoted and fixed at any desired angle
within the "A" range according to the operating position
or the figure of the workpiece.
1
1. Lock lever 2. Arm
Loosen the lock lever by raising it. Pivot the arm to the
desired position, and secure the lock lever to fix the arm
firmly.
Replacing arm
By replacing the standard-equipped arm by optional
one, 6 mm or 13 mm width belt can be used. Remove
the arm by loosening the screw that secures the arm.
Insert the arm that fits the belt to be used, and tighten
the screw firmly.
► Fig.1: 1. Screw 2. Arm
2
"A" range
Switch action
► Fig.2: 1. Lock button 2. Switch trigger
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, and then release it.
Speed adjusting dial
► Fig.3: 1. Speed adjusting dial
The belt speed can be infinitely adjusted between 5 m
and 28 m per second by turning the speed adjusting dial
to a given number setting from 1 to 6.
Higher speed is obtained when the dial is turned in the
direction of number 6; lower speed is obtained when it
is turned in the direction of number 1. Select the proper
speed for the workpiece to be sanded.
CAUTION:
• The speed adjusting dial can be turned only as
far as 6 and back to 1. Do not force it past 6 or
1, or the speed adjusting function may no longer
work.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing abrasive belt
► Fig.4: 1. Arm 2. Abrasive belt 3. Cam lever 4. Rear
pulley
Pull the cam lever all the way out. Install the belt over
the rear pulley, and slip the belt over the front pulley,
with the belt pulled out to the front arm. Return the cam
lever to the original position.
Adjusting belt tracking
► Fig.5: 1. Arm 2. Adjusting dial
Switch on the tool and make sure that the belt is aligned
properly.
Use the adjusting dial to center the belt tracking. Turn
the adjusting dial clockwise to incline the arm to the
right, or counterclockwise to incline it to the left.
5 ENGLISH