Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Charging The Accumulator (Chargeable Battery)
If your pager`s power is provided by an accumulator, a regular
charging in the Charging Unit LX2 / LX4 is necessary.
For charging, open the hinged frame of the charging unit and put
the pager into the charger (clean the charging contacts,regularly).
Afterwards close the hinged frame again. Now the symbol 6
is displayed. In case, after a while, it does not, please take off the
pager and place it again.
If the pager`s accumulator is totaly discharged it may happen that
it is not turned on automatically, when being inside the charger.
In that case leave your pager inside the charger for some min-
utes. Afterwards take it off and place it again in order to start the
superviced charging procedure.
The accumulator is charged in a superviced way inside the
Charging Unit, i.e. it is charged as long as necessary, depending
on the charging state. After the superviced charging is done, the
charger moves over to a trickle charge mode. This procedure is
to achieve the longest possible accumulator life.
Do not leave your pager inside the charger, permanently.
Important: To make possible the superviced charging procedure
and reliable Low Battery Alert function , it is necessary to set the
nominal capacity of the battery or accumulator during program-
ming of the pager (refer to statements of the manufacturer, i.e.
800mAh).
Note: If you want to use a new accumulator, it has to be charged
one time, first. Otherwise the charging state is unknown and the
charging procedure (described above) cannot work. Therefore,
the accumulator should not be taken out of the pager
unnecessarily. Factory-new accumulators reach there maximum
possible capacity after several cycles of charge and discharge,
only.
Being inside the charging unit, the pager is set to audible alert
mode automatically (vibrator turned off).
Werbung
