Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Transmitting Messages (advanced pagers only)
After choosing the Message Transmit Symbol á in the function
menu you can transmit any received message to a PC, printer or
large size display via Data Adapter (adapter with serial inter-
face).
Pager Protect Function
In case your pager displays PAGER PROTECT it cannot
receive messages any longer because it was set to a remote
maintenance condition by the paging system`s transmitter („over
the air", advanced pagers only).
Low Battery Alert
When the battery voltage drops, the symbol 9 (warning level
1) is displayed. Whenever the symbol = (warning level 2) is
displayed, the battery must been charged or replaced very soon.
When the battery voltage reaches one of the warning levels the
pager emits a low battery alert. If you do not recognize the alert
(you do not press any button) there will be a repetition in regular
intervals and the symbol 9 or = flashes.
Battery Replacement
To install or replace the battery, place the pager face down in the
palm of your hand. Then:
1.
Unlock the battery door by sliding the door latch up with
your thumb.
2.
Slide the battery door to your right.
3.
LX2: Lift the battery door (without removing the battery
door).
LX4: Remove the battery door.
4.
Install or replace the battery.
Important: Take care to ensure correct polarity of the battery
(see polarity markings next to the battery door). All stored mes-
sages remain stored during a battery change.
Do not use carbon zinc batteries.
Caution: Never operate your pager in the charging unit if it is
fitted with a non-chargeable battery – Risk of explosion.
Werbung
