AEG PNEUMATIC 6000 S Gebrauchsanleitung Seite 5

On-off switch
Depth gauge
Handle
ENGLISH
Switching on: Press on-off switch
Switching off: Release on-off switch
The speed can be infinitely varied by
pressing the On-/Off switch.
The depth gauge can be attached
either to the right or to the left hand
side of the auxiliary handle. Push the
depth gauge holder into the auxiliary
handle until the locking mechanism
engages. To remove the depth
gauge depress the locking
mechanism and remove the depth
gauge from the handle.
For drilling identical depths insert the
depth gauge into the boring of the
depth gauge holder, push it back by
the required drilling depth and fasten
it.
In order to twist the additional handle
loosen it as shown in illustration and
move to the required position.
Refasten additional handle.
The auxiliary handle can also be
attached to the side of the housing.
This position should be preferred when
drilling into the floor or into the ceiling,
for example.
Remove the auxiliary handle from the
front position and screw it down at the
side of the machine.
4
PNEUMATIC 6000 S