AEG BS2E 9.6 T Gebrauchsanleitung Seite 6

On-/off switch
Torque
Adjustment
Bit storage
Advice for
operation
Tips on drilling in
metal
Tips on drilling
into wood
Tips for
screw-driving
ENGLISH
Switching on: Press on-off switch
Switching off: Release on-off switch
The speed can be infinitely varied by
slowly releasing/pressing the switch
trigger.
For drilling twist the adjustment ring such
that the symbol
safety clutch is now locked and the
maximum torque available.
For screwdriving at constant cutting
depth torque speed pre–selection with
torque adjustment ring is possible. For this
turn torque adjustment ring until the
desired torque level faces the marking.
Torque level 1: minimum torque speed for
screwdriving
Torque level 7: maximum torque speed for screwdriving
When often screwing in the "drilling" (
choose a torque which is suited to the working material and size of the screw. By
doing so you can avoid the bit sliding of the screw head and damaging the
screwdriver bit.
Bit storage for compartment screwdriver
bits
Temperatures in excess of 50
Avoid extended exposure to heat or sunshine (risk of overheating).
Center punch the point you have marked for drilling.
Always hold sheet metal firmly in a vice.
Lay a block of wood under thin metal to prevent it from distorting.
Use HSS spiral drill bits. (For white cast iron, use drill bits with special tips.)
Before drilling large-diameter holes, first drill a small pilot hole.
Use lubricant:
Steel: Oil
Aluminium: Turpentine, paraffin
Brass, copper, cast iron: no lubricant, but take the drill out of the hole frequently to
cool it off.
Center punch the point you have marked for drilling. To prevent the wood from
splintering when the drill bit tip breaks through, lay a piece of scrap wood underneath
it, or drill from both sides.The maximum drill-diameter can only be reached with a
Forstner–drill bit.
Use screwdriver bits of the appropriate size and shape.
Suitable screws can be driven into softwood without pre-drilling.
Pre-drill into hardwood or for screws of large diameter.
Pre-drill further for countersunk screws.
For woodscrews threaded less than their full length, pre-drill approx. half the length
of the screw.
BS2E 7.2 T, BS2E 9.6 T, BS2E 12 T, BS2E 14.4 T, POWERBASE 60
6
faces the marking; the
) setting, the motor can overheat. Please
o o
C (122 F)reduce the performance of the battery pack.