AEG BS2E 9.6 T Gebrauchsanleitung Seite 5

Inserting tools
Battery pack
Battery pack
reception
(only applicable
for
BS2E 12 T
BS2E 14.4 T:
Removing the
battery pack
Changing gear
Switching
between forward
and reverse
rotation
ENGLISH
The chuck can be used for drill bits or
screwdriver bits.
For this purpose, Open chuck, insert the
selected bit and tighten chuck.
Fully charge new or long stored battery packs before using your battery tool. Battery
packs only reach full capacity after 4 – 5 chargings.
Insert the battery pack from behind into the
machine until it engages (as shown in
illustration).
The battery pack can be inserted either
way into the holding device:
From the front:
The shape of the machine is more
compact and therefore well suited for
working in restricted space.
From the back:
Due to the optimum weight distribution the
machine is ideally balanced. This protects
the wrist when driving screws or drilling
horizontally.
Press together the clamps and remove the
battery pack in direction of arrow.
The gears can be changed when the
machine is switched off or is running under
no load.
Gear change lever in position 1: 1st gear
Gear change lever in position 2: 2nd gear
Select direction of rotation with reversing
lever.
Due to a lockout mechanism, the reversing
lever can only be switched when the
On-/off switch is not depressed.
BS2E 7.2 T, BS2E 9.6 T, BS2E 12 T, BS2E 14.4 T, POWERBASE 60
5
L T
1 2 V O
1
2