Fleem SRE 4010 NF Gebrauchsanweisung Seite 35

O
Air
Vent
fuel filter
GB
35
Manual SRE4010NF.indd 35
MAINTENANCE
Switch off the heater, disconnect the plug from the mains and let
it cool down, before you start any maintenance work. Your heater
needs hardly any maintenance.
It is, however, important that you clean the air filter and the vent
filter with a vacuum cleaner and a brush and the grid with a damp
cloth, both on a weekly basis. Remove the air filter occasionally and
clean it with soapy water or with a vacuum cleaner. Prior to reinstal-
lation, make sure that the air filter cap has fully been dried.
Regularly inspect the fuel filter as well:
Remove the removable tank from the heater and remove the fuel filter
1
Some drops may leak from the filter; keep a cloth at hand.
Remove the dirt and water by gently tapping the fuel filter upside-down
2
against a hard surface. (Never clean it with water!)
3
Reinstall the fuel filter into the heater.
We recommend to remove dust and stains on the outside of the heater
from time to time with a damp cloth, otherwise these may cause stains that
are hard to remove.
Do not remove any components yourself. Always contact
your dealer for repairs. When the power cord is damaged,
it may only be replaced by an authorised engineer. Use a
new original cord.
12-8-2010 14:52:37