Fleem SRE 4010 NF Gebrauchsanweisung Seite 31

5
Let the remaining fuel in the pump flow back into the jerrycan and carefully
remove the pump. Carefully screw the fuel cap back on the tank. Clean off
any spilled fuel.
6
Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
C
SETTING THE CLOCK
It is only possible to set the correct time, when the heater is connected to
mains. Press the mode key once and the word TIME will appear on the display.
Use the + and – buttons to enter the actual time.
When the heater has been unplugged (or after a power failure), the time
needs to be set again.
D
IGNITING THE HEATER (AUTO RESTART)
When used for the first time, a new heater may give out some fumes for a short
while. You therefore have to provide extra ventilation.
Always ignite the heater with the
cigarette lighter.
A little white smoke and smell during ignition is normal. Just press the button
to ignite the heater. The green power lamp inside the button will start to blink,
indicating that the ignition procedure is running. This will take about 2 or 3
minutes. Once the heater is really burning, the power lamp will light.
continuously. This heater will restart automatically after a power cut when the
heater was in "on" position prior to power cut. This makes it possible to switch
the appliance on / off by interrupting / enabling the power supply (for instance
through a mobile phone switch).
E
QUICK IGNITION
Sometimes you may know in advance that you will be manually switching on
the heater within 12 hours, but you do not want to wait 2-3 minutes (see chap-
ter D) at that particular moment. For these occasions this heater is equipped
with the "quick ignition" function. This function will prepare the heater such that
at the moment you want to switch on the heater that upon pressing the button
the heater will start within 5 seconds. To start the "QUICKIGNI." function press
the quick ignition button.
In quick ignition mode:
- the electrical power consumption is 100 Watt
- the air at the outlet is slightly warmed
- is automatically cancelled when timer function is set
- is automatically switched off after 12 hours
- can be cancelled by pressing the QUICKIGNI. button
again (the light will now be off).
The quick igition mode has to be enabled for at least 2-3 minutes before the
heater can be started.
GB
31
Manual SRE4010NF.indd 31
button. Never use matches or a
12-8-2010 14:52:36