Fleem SRE 4010 NF Gebrauchsanweisung Seite 32

F
SETTING THE REQUIRED TEMPERATURE
The temperature setting can only be adjusted when the heater is burning. Use the
buttons + and – to adjust the temperature. The available temperature range is +6°C
minimum to +30 °C maximum. The desired temperature is stored in the memory and
remains after a restart or power failure.
G
USING THE TIMER
The timer allows you to activate the heater at a certain time. In order to use the timer,
the correct actual time must have been set (refer to chapter C).
To set the timer:
Press the mode button twice and the word TIMER will appear on the display. Use the
buttons + and – to set the time at which the heater has to start. Press the
first, then press the TIMER button within 1 sec. The TIMER lamp switches on and the
heater is ready to start at the desired time.
H
SWITCHING OFF THE HEATER
Press the button. The green lamp inside the
heater stops within approximately 1 minute. A little white smoke and smell during the
extinguish period is normal.
I
SAVE MODE (IF APPLICABLE)
In the save mode the heater will switch off when the room temperature, as sensed by
the heater, rises 3 °C above the set temperature. The save mode can be activated
with the button SAVE. The lamp in the button will switch on and the heater will now
switch off when the room temperature rises 3°C above the set temperature. The
heater will start again when the room temperature drops below the set tempera-
ture. The save mode can be cancelled by pushing the SAVE button again, the lamp
switches off.
J
THE INFORMATION DISPLAY
The information display not only serves as an indicator of the (set) time and
temperature, it also indicates any malfunctioning of the heater. The code on the infor-
mation display tells you what is the matter:
Manual SRE4010NF.indd 32
button
button will switch off and the
GB
32
12-8-2010 14:52:37