Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating Instruction
EN
IMPORTANT
Read carefully before use
Keep for later reference
The latest version of the Operating/
Fitting instructions is also available
in our online catalogue:
herthundbuss.com/online catalogue
www.herthundbuss.com
J9300004
Operating Instruction
Filler/bleeder unit, brake fluid
Brake bleeding and changing brake fluid
1. Connect the brake bleeder to com-
2. C heck the level of brake fluid in the re-
3. M ount the rubber fitting on to the bleed
4. Activate trigger of brake bleeder and
5. A llow fluid to be drawn until new fluid
6. Repeat the above procedure at each
Refer to specific procedures and in-
structions from the vehicle manufactur-
ers service manual
7. At completion of bleeding, remove and
Technical data:
6
7
pressed air supply.
Min 80psi - Max 130psi
servoir and add fluid if necessary. If fluid
is being changed, evacuate reservoir and
fill with new fluid.
screw/valve and hang bleeder unit at a
point higher than the bleed screw/valve.
hold for 3 to 4 seconds to allow full vacu-
um to build in canister. With trigger held
on, open bleed screw/valve and fluid will
be drawn from the system.
is visible, close and tighten bleed screw/
valve and remove the rubber fitting - when
the hose is empty release the trigger.
wheel.
NOTE
empty canister to prevent accidental
fluid spillage.
J9300004
IMPORTANT
Check and maintain the level of
brake fluid in the reservoir after each
wheel.
Before bleeding, remove and clear
bleed screw, apply copper or silicone
grease to minimize air leaks around
the bleed screw thread and to pre-
vent seizing in place.
Vacuum bleeding may cause a small
amount of air to be drawn past the
brake bleed screw thread giving the
operator a false impression that air
is being drawn from the system. This
does not affect bleeding of the brake
system.
After bleeding, check brake perfor-
mance.
Maintenance: To maintain bleeder
in good working order, periodically
dismantle unit and wash all com-
ponents with water only. This will
prevent any build up of brake fluid
being exhausted from rear of gun.
DANGER
Not to be used with flammable liq-
uids. Not to be used with hot liquids.
EN
Werbung
