Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Using the Jig for Cabinet Hardware Installation
When building frameless cabinets, the jig can be used to correctly mount concealed
hinge plates and first hole alignment for most drawer slides.
Note
Check your hardware mounting instructions before drilling. The drill guide holes
are 1.45" (37 mm) from the sides of the jig with 1.25" (32 mm) between holes.
Marking Concealed Hinge Mounting Holes
a.
Mark the desired center line of the hinge on the cabinet.
b.
Position the jig (A) using the position indicator window to align the center of the
two drill guide holes.
c.
Clamp the jig to the frameless cabinet.
Important
To use the provided screws from the hinge manufacturer, only use the drill
bit to mark the location of the screws.
d.
If using a standard
wood screw, bring your
drill up to speed and
lightly touch the cabinet
to break the surface.
e.
If using a 5 mm
system screw, use
the 5 mm drill bit to
drill the hole.
A
9
Werbung
Kapitel
Inhaltsverzeichnis
