Connect Jigs Together; Maintenance; Care And Cleaning; Troubleshooting - Kreg KMA3225 Benutzerhandbuch

Connect Jigs Together

Connect two or more jigs together for
longer drilling capability. Insert the top
of the second jig into the extension
connector at the bottom of the first jig.

Maintenance

Keep all parts clean of dust and debris.
Replace the drill bit when it is dull.

Care and Cleaning

To clean, wipe with a clean rag or blow compressed air on all parts.
To store, place all parts and hardware into the storage positions on the back of the jig.

Troubleshooting

Problem
It is difficult to drill
the hole.
It is difficult to drill
the hole.
There is excessive
tear out on holes.
The side to side
alignment is off.

Accessories

KMA3210 1/4" Shelf Pin Jig Drill Bit
Possible Cause
The drill is in reverse.
The bit is dull.
The bit is dull.
The jig is not clamped
properly.
The drill bit is started while it
is in contact with the wood.
Not using the same
reference end.
Solution
Check and reset the drill to forward.
Replace the bit.
Replace the bit.
Check and clamp the jig properly.
Insert the drill bit into the drill guide
and bring the drill up to speed before
contacting the wood.
Use the same reference end for both
sides of the cabinet.
KMA3215 5 mm Shelf Pin Jig Drill Bit
11