Inline WOOME II Bedienungsanleitung Seite 23

NOTE!
Since a second playback device could still be connected by Bluetooth and could also
play music via the speaker, you should delete the memory of the speaker by pressing
the „V-" and „V+" buttons simultaneously for about 2 seconds. The LED is briefly red
Note
and indicates that the memory has been erased successfully. If a playback device was
connected via Bluetooth at this time, the acoustic signal „Disconnected" is also emitted.
NOTE!
Even if the playback device is connected to a speaker by cable, the function TWS
(True Wireless Stereo) is supported. See the chapter below.
Note
8.8 TWS - True Wireless Stereo - pairing of two speakers
The TWS is used to couple two InLine® WOOME II speakers, which are controlled in parallel by one
playback device. Make sure that both speakers are not more than one meter apart and turn on both
speakers. To establish a wireless connection to one of the speakers, first follow the steps described
in chapter 8.2 Bluetooth connection setup or 8.3 Connection setup via NFC. Once the connection
has been successfully established, press the „A
button on the second speaker. A red and blue LED flashing alternately on both speakers now indica-
tes that they are ready to connect. Pairing is automatic but may take a few seconds. The successful
connection between the two speakers is indicated by the LED's flashing blue twice at an interval of
approx. 3 seconds on both speakers. Now you can start an installed app on your playback device to
play audio files and hear them from both speakers.
www.inline-info.com
B" button on this speaker, then press the „A
In order to ensure optimal playback, the two speakers should not be more than 8 meters apart on the
same floor as well as to the playback unit.
Buttons used for playing audio files in TWS mode:
• Play/Pause: Play and pause an audio file
• V-: Decrease the volume
• V+: Increase the volume
NOTE!
The buttons only work on the speaker first connected to the playback device and cont-
rol both speakers in parallel. You can also turn off both speakers in parallel by holding
Note
down the power button on one speaker.
NOTE!
In this case as well, the speaker saves the last connected playback device as well as
the connection settings to the second speaker. After switching both speakers off and
on, the connection setup is automatically performed, if the Bluetooth device is still acti-
Note
B" vated, both speakers are close to the playback device and close together.
10