IKEA ENEBY 20 gen 2 Bedienungsanleitung Seite 6

Set bass and treble
Disable the auto-off function
Factory reset
Safety and important notice
WARNING:
• Risk of overheating! Never install the product
in a confined space. Always leave a space of at
least 5 mm around the product for ventilation.
Ensure curtains or other objects never cover the
ventilation slots on the product.
• Never place the product or batteries near open
flames or other heat sources, including direct
sunlight.
• Only use this product indoors. The apparatus
shall not be exposed to dripping or splashing, no
objects filled with liquids, such as vases, shall be
placed on the apparatus.
• Never place this product on other electrical
equipment.
• The mains plug or an appliance coupler is to
be used as a disconnect device, the disconnect
device shall remain readily operable.
• If the supply cord is damaged, replace it with a
new cord set which is type-approved for your
country.
• Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such as
sunshine, fire or similar.
Press and hold the knob (1). Release the knob when the LED light turns
red the third time.
This activates the bass setting. The LED light flashes slowly. Turn left/
right to adjust the bass. Confirm the bass setting and activate the
treble setting by pressing the knob once. The LED light flashes quickly.
Turn left/right to adjust the treble. Confirm by pressing the knob once
and this also exits the sound settings.
Press and hold the knob (1). Release the knob when the LED light turns
red the fourth time.
A confirmation sound will be played. ENEBY will now not turn off
automatically.
Press and hold the knob (1). Release the knob when the LED light
turns red the fifth time (after approximately 30 seconds). A louder
confirmation sound will be played. The factory reset will clear all
Bluetooth devices and sound settings, and it will activate the auto-off
function.
IMPORTANT!
• The speaker is for indoor use only and can be
• Do not leave the speaker in direct sunlight or
• Do not subject the speaker to wet, moist or
• The range between the speaker and the receiver
• Different building materials and placement of the
• Too high volume can damage your hearing.
• Do not touch the acoustic components.
• Don not use the product as a shelf or stand.
CARE INSTRUCTIONS
To clean the speaker, wipe with a moist cloth. Never
submerge the speaker in water.
NOTE!
Never use abrasive cleaners or chemical solvents as
this can damage the product.
used in temperatures ranging from 0º C to 40º C.
near any heat source, as it may overheat.
excessively dusty environments, as this may
cause damage.
is measured in open air.
units can affect the wireless connectivity range.
6