Firmware Recovery; Usb Otg Firmware Upgrade - Bullit Rapsody Rsh-100 Bedienungsanleitung

HDD BASED MULTI A/V PLAYER
BULLIT RAPSODY RSH-100

Firmware recovery

If the power is turned off during a firmware upgrade, this may damage the
RSH-100 and lead to a blank screen. In this case, recover the firmware by
following the steps below.
If the firmware file is not stored in the HDD, connect the RSH-100 to a PC
using the USB cable. Although the main firmware is damaged, the PC can
still recognize the RSH-100 as a USB storage unit. Copy the firmware file to
the RSH-100.
Disconnect the RSH-100 from the PC.
While pressing PREV, press POWER located on the front side of the RSH-
100.
The Firmware upgrade screen appears on the front of the LCD monitor. The
RSH-100 automatically searches for the latest firmware in the HDD and
recover itself.
When completed, the system reboots automatically.

USB OTG firmware upgrade

Download the latest OTG Firmware from www.bull-it.ch.
Unzip the downloaded firmware and you will see the files below.
·
Connect the RSH-100 to a PC using the USB cable and turn the power on
while pressing PLAY/PAUSE'.
In this case, the RSH-100 is recognized as being in USB OTG firmware
upgrade mode, not as a USB removable storage unit.
Run the 'EndUser.exe' file among unzipped files.
BULLIT RAPSODY (c) 2005 by BULLIT™
English / 175
www.bull-it.ch