Using Usb Host - Bullit Rapsody Rsh-100 Bedienungsanleitung

HDD BASED MULTI A/V PLAYER
BULLIT RAPSODY RSH-100

Using USB Host

Using USB Host feature
Before using the USB HOST feature, make sure the primary
HDD partition in the RSH-100 is partitioned in FAT32.
Connect the USB device to the RSH-100 using the OTG cable.
As shown in the picture above, connect the cable from the USB device to the
OTG socket located on the back of the RSH-100.
Turn on the power once the USB device is connected. A red HDD usage
indicator light on the NAVIGATION button flashes while the system is trying
to recognize the HDD. It takes about 5 -10 seconds.
When the red light of the NAVIGATION button is turned off, it is ready to
copy.
To copy files from the connected USB device, press PLAY/ PAUSE.
As soon as PLAY/PAUSE is pressed, files from the USB devices are copied to
the RSH-100.
The green light flashes on the left cursor and the red light disappears on the
NAVIGATION button. Files are now being copied. It takes about 30 – 40
seconds to copy 30MB.
When a green light flashes on the right cursor, the RSH-100 does not
support the connected USB device. Currently unsupported devices may be
supported in later firmware upgrades.
If everything is OK, the light on the NAVIGATION button is turned off.
Remove the USB device from the OTG socket. Once the files have been
copied from a USB device, these files are not recopied unless you first
remove and then reconnect the USB device.
Copied files can be viewed in the DSC00000 folder in root directory. If a
folder with the same name exists, the number of the folder name increases.
BULLIT RAPSODY (c) 2005 by BULLIT™
English / 172
www.bull-it.ch