Important Safety Instructions - Bullit Rapsody Rsh-100 Bedienungsanleitung

HDD BASED MULTI A/V PLAYER
BULLIT RAPSODY RSH-100

Important safety instructions

Make sure the power is off when connecting any cables between the RSH-
100 and a TV.
The RSH-100 is designed to turn off automatically when connecting or
disconnecting the USB cable while the power is on. This is NORMAL.
The RSH-100 sets itself in storage mode when the power is on and the USB
cable is connected. To playback multimedia files, the USB cable MUST be
removed from the RSH-100.
Make sure the jumper setting of the HDD to be installed in the RSH-100 is
set at Single Master, otherwise the HDD will not be recognized by the
RSH-100.
When installing a new HDD, make sure the HDD is partitioned and
formatted in advance.
In order to utilize the USB Host (OTG) function, the primary partition of the
HDD MUST be formatted via FAT32, as the USB OTG does not support
NTFS.
Any HDDs formatted via NTFS will not be recognized, as Windows 98 and
Window ME do not support NTFS format. In order to use the HDD properly,
delete the old partition and reformat in accordance with FAT32.
To use the RSH-100 in your car, you MUST use the manufacturer's
designated Car Pack (option).
Never turn off the RSH-100 in the middle of a firmware upgrade. If you do
so, the RSH-100 will be damaged and may not run properly.
BULLIT RAPSODY (c) 2005 by BULLIT™
English / 123
www.bull-it.ch