Kurze Beschreibung - HIKMICRO E1L Schnellstartanleitung

Using Environment
● Make sure the running environment meets the requirement of the device. The operating temperature shall
be -10 °C to 50 °C (14 °F to 122 °F), humidity shall be 90% or less, and height ≤5000 m.
● Place the device in a dry and well-ventilated environment.
● DO NOT expose the device to high electromagnetic radiation or dusty environments.
● DO NOT aim the lens at the sun or any other bright light.
● When any laser equipment is in use, make sure that the device lens is not exposed to the laser beam, or it
may burn out.
● The device is suitable for indoor and outdoor uses, but do not expose it in wet conditions.
● The level of protection is IP 54.
● The pollution degree is 2.
Technical support.
● The https://www.hikmicrotech.com portal will help you as a HIKMICRO customer to get the most out of your
HIKMICRO products. The portal gives you access to our support team, software and documentation, service
contacts, etc.
Emergency
● If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the power cable, and
contact the service center.
Laser
Manufacture Address
Room 313, Unit B, Building 2, 399 Danfeng Road, Xixing Subdistrict,Binjiang District, Hangzhou, Zhejiang 310052,
China
Hangzhou Microimage Software Co., Ltd.
COMPLIANCE NOTICE: The thermal series products might be subject to export controls in various countries or
regions, including without limitation, the United States, European Union, United Kingdom and/or other member
countries of the Wassenaar Arrangement. Please consult your professional legal or compliance expert or local
government authorities for any necessary export license requirements if you intend to transfer, export,
re-export the thermal series products between different countries.

1. Kurze Beschreibung

Die tragbare Wärmebildkamera ist eine Kamera zur Aufnahme von Wärmebildern. Der integrierte
Warning: The laser radiation emitted from the device can cause eye injuries, burning
of skin or inflammable substances. Prevent eyes from direct laser. Before enabling the
Light Supplement function, make sure no human or inflammable substances are in
front of the laser lens. The wave length is 650 nm, and the power is less than 1 Mw.
The laser meets the IEC60825-1:2014 standard.
Laser maintenance: It is not necessary to maintain the laser regularly. If the laser does
not work, the laser assembly needs to be replaced in the factory under warranty. Keep
the device power off when replacing laser assembly. Caution-Use of controls or
adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure.
7
Deutsch