Led-Status - PATONA WB1-11 Bedienungsanleitung

5. LED status
Color Status
off
yellow
green (pulsed)
green
red
6. Error codes and suggested solutions
Error Possible reason
Overvolta- AC input voltage too
ge high
Undervol- AC input voltage too
tage low
Meaning
The Wallbox is ready for
use.
The charging cable is
connected.
The charging process is
active.
The charging process is
completed.
An error has occurred.
Solutions
Input voltage must be checked.
If the voltage is above 264V (AC), wait
until the power grid is back in the normal
voltage range. Switch the Wallbox off and
on again.
If the error persists, please contact the
dealer.
The input voltage must be checked.
If the voltage is below 140 (AC), wait until
the power grid is back within the normal
voltage range. Switch the Wallbox off and
on again.
If the fault cannot be rectified, please
contact the dealer or a specialist compa-
ny.
- 19 -
Action
Please connect the
charging cable.
Please hold the RFID
card up to the card
reader.
Please wait or cancel
the charging process.
Please remove the
charging cable.
Please check chapter
6. Error codes.